Maintenance method of energy-saving socks setting machine

Update:21 Sep 2019

Maintenance method of energy-saving socks setting machi […]

Maintenance method of energy-saving socks setting machine
1. Cylinder (Dg1100×6): welded by steel plate. There is no long-term accumulation of water (steam cooling water) in the cylinder. After the damp heat setting, the cooling water should be drained and dried, and the inner surface should be regularly inspected for paint detachment and rubbing and falling. If any, it should be replenished with high temperature. Rust paint to prevent local rust. Note: The vacuum is not more than 0.07MPa (actually more than 0.06MPa) when used to prevent instability.
2. Energy-saving socks setting machine jacket: It is made of steel plate. Used for dry heat setting. Mainly carried at the head 45 ° fold. During maintenance, add 80-100 mm asbestos cement insulation layer according to the drawing requirements, and drain the cooling water inside the jacket after each use.
3, 2 support tubes and 11 accessory tubes: Check whether the teeth are intact during maintenance. Apply anti-corrosion lubricant such as molybdenum disulfide on the thread before installing the pipe, and install mats at the flange connection to ensure various air pipes. No water leakage, no air leakage.
4, energy-saving socks shaping machine moving ring, fixed block, roller, rack, handle and other components: pay attention to silk or other dirt embedded in the roller, affecting the rotation. If the roller is sluggish, loosen the compression screw properly.
5, energy-saving socks shaping machine various pressure gauges, thermometers, safety valves, jackets, vacuum gauges, etc.: For these instruments, must meet the specified specifications and models, to achieve the specified measurement range and accuracy level; regular inspection of its sensitivity, accuracy Degree, reliability.